PART 1 • English
14
3. Selected by on-screen channels list
You can also select the required channel directly from on-screen channel
list. This is displayed using the receiver’s main menu. See chapter 5.1.1 TV
Channel list in this manual for operation detail. Alternatively you can call
up channel list by pressing OK in viewing mode.
4. Selected by EPG
You can also select the required channel directly from electronic programme
guide (EPG). This is displayed by pressing EPG button on remote control.
See in the below chapter of this manual for operation detail.
6.2 Accessing the Electronic Program Guide (EPG)
1. Press EPG button to enter EPG menu.
2. Press numeric button [2] to switch between channel list, events schedule
of the selected channel and now/next events.
3. In the event schedule, press numeric button [3] to book the selected
event, press OK to open the Detail menu for the selected event.
4. Press numeric button [1] to open the Booking list menu.
6.3 Accessing the favourite channels
1. Press FAV button to enter favorite group menu.
2. Press “UP” or “DOWN” cursor buttons to select the desired favourite group.
3. Press OK button to enter the favorite channels list, and press pq
buttons to select the favourite channel.
A.1 TROUBLESHOOTING
There may be various reasons for the abnormal operation of the receiver. Check the
receiver according to the procedures shown below. If the receiver does not work
properly after checking it, please contact the dealer. Do NOT open the receiver cover.
It may cause a dangerous situation and the warranty will get void.
Problem Possible cause What to do
Standby light not lit
Display light* not lit
Mains lead unplugged
Mains fuse blown
Check mains lead
Check fuse
No signal found Aerial is disconnected
Aerial is damaged/misaligned
Out of digital signal area
Active antenna requires to switch
ON antenna power/external feed
Check aerial lead
Check aerial
Check with dealer
Switch receiver’s Antenna Power
ON/ connect external feed
No picture or sound on
TV/VCR**
Scart/ AV* is not selected on
your TV
TV or VCR are not connected to main
Switch to correct TV input
Check mains lead
Scrambled channel message Channel is scrambled Select alternative channel
To Next Page
Loading...
Need help?
General
