NOTE: For successful editing of channel list (see ch 7.1), switch O LCN function.
7.4 Picture
Use this menu to match your receiver to your TV set.
The following settings are available:
Aspect Ratio: Select the aspect ratio that matches your TV. The options are:
Auto In most cases this default setting should suce, but it can be changed to
cope with broadcast errors or personal taste.
16:9 widescreen A 4:3 programme will be show full screen, with sideways stretched content.
16:9 Pillarbox A 4:3 programme will be shown normally, but with black bars to the left and
right.
16:9 Pan&Scan A 4:3 programme will be shown as a centre blow up to ll the whole screen,
missing content to the left, right, top and bottom of the programme.
Resolution If the video quality does not appear correctly, change the setting. These
settings match the most common settings for HDMI.
576p: For digital SD TVs (some digital TVs do not support this mode).
720p: For digital HD TVs (on HDMI connection).
1080i: For digital HD TVs (on HDMI connection).
1080p (50 Hz): For digital HD TVs (on HDMI connection).
Auto: The best possible resolution available will be auto negotiated by between
TV and receiver (‘handshake') when using a modern digital HD TV when
connected with an HDMI cable.
TV Format Options are PAL and NTSC. For European broadcasts, the TV format is PA L
(Default).
7.5 Channel Search
Auto Search This menu allows you to search for channels from all available frequencies
for your selected region automatically. Be aware that all previous installed
channels and favourite list(s) will be deleted. The new-found channels will be
installed in the channel list and afterwards you can create a new favourite list
if you like. Press OK to start the scan.
Manual Search Select a particular channel to do a search on just one (known) frequency.
Press OK to start the scan. The signal quality bar might be useful to
check if the frequency is indeed in use.
Country Select the correct country where this receiver is used. If failing to do so, may
result in that channels appear randomly in the channel list, instead of a more
logical order.
Antenna Power Set to On if you use an active antenna. When set to On, 5 V will be present at
the RF in connector of the receiver. Select O for passive antennas.
Scan Mode Select between FTA (Free-To-Air), which will only install Free-to-Air channels
or All, which will install all found channels, even if they are scrambled. Then
select Auto Search or Manual Search and press OK to start scanning.
13
To Next Page
Loading...
