Struers LaboPol-35 - Supplying Water; Water Outlet; Water Inlet

LaboPol-35
Instruction Manual
6
 Connect the outlet hose to the water outlet on the back of the
machine and secure the hose using the hose clamp.
 Lead the other end of the outlet hose to the drain. Be absolutely
sure to place the outlet hose with a steady slope to prevent the
water from being discharged too slowly, which may cause
overflow or blocking the water outlet. Avoid sharp bends on the
outlet hose.
 Connect the inlet hose to the water tap and secure with a hose
clamp. The fittings (gasket, union nut and reduction ring)
supplied with the machine may also be used for the connection.
Supplying Water
Water Outlet
Water Inlet
IMPORTANT
Only connect to cold water.
REMEMBER
Avoid sharp bends in the drain hose and make sure that the hose slopes
throughout its length.