Struers LaboPol-35 - Getting Started; Checking the Contents of Packing; Unpacking LaboPol-35; Placing LaboPol-35

LaboPol-35
Instruction Manual
2
1. Getting Started
In the packing box you should find the following parts:
1 LaboPol-35
(Grinding/polishing machine)
1 Pressure hose 3/4" x 2 m
1 Filter gasket
1 Gasket ø11/ø24 x 1.5 mm
1 Reduction ring with gasket
1 Drain hose, ø38 mm x 3 m
1 Drain elbow pipe
2 Hose clamps
1 Protection ring
Mains cable
1 Set of Instruction Manuals
 Detach LaboPol-35 from the bottom of the packing case by
removing the four screws from below.
 Place LaboPol-35 placed on a steady table with an adequate
working height. The machine must be close to the power supply,
water mains and water outlet facilities.
Checking the Contents of
Packing
Unpacking LaboPol-35
Placing LaboPol-35