Stryker LUCAS 3 Implementation Guide

Page 3
• If you have not yet registered any LUCAS 3, v3.1 device on your
LIFENET account the navigation step 8 “Assign to Devices” will be
empty. Skip this step, and continue to step 9 “Summary”. Review your
setups, then check the box “Assign as default prole to new devices” if
you want to make these settings default for all new LUCAS devices that
are registered to your account. This means the created Setup Options
prole will automatically be applied to all newly enrolled LUCAS 3 devices.
• If you have already registered LUCAS device/s on your LIFENET account,
they will appear in a list in step 8 “Assign to Devices”. Check which devices
you want the new setup options to be applied to, and continue to step 9
“Summary”. Review your setups, then check the box “Assign as default
prole to new devices” if you want to make these settings default for all
new LUCAS devices that are registered to your account. This means the
created Setup Options prole will automatically be applied to all newly
enrolled LUCAS 3 devices.
• You may print out the summary of your device Setup Options for reference.
Assign devices
Print
Back to contents

Stryker LUCAS 3 Specifications

General

Device Type	Chest Compression System
Power Source	Rechargeable Lithium-ion Battery
Compression Depth	5.3 ± 0.2 cm (2.1 ± 0.1 in)
Battery Life	45 minutes of operation
Battery Charge Time	Approximately 4 hours
Operating Modes	Pause
Patient Size	Fits most adult patients
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	–20 to +60 °C (–4 to 140 °F)
IP Rating	IP43
Compression Rate	100 compressions per minute