Stryker LUCAS 3 Implementation Guide

Page 7
• Select the serial number of the LUCAS device you want to connect
and click ”Next”.
Troubleshooting
If no LUCAS device/s is/are detected;
1. Ensure that the Bluetooth LED on LUCAS user interface is blinking, if
not, go back to previous step to initiate the LUCAS Bluetooth connection.
2. Make sure your PC Bluetooth is ON and discoverable.
3. Make sure you are using the Microsoft Bluetooth driver and you have
the latest installed.
4. If the above doesn’t work, try with a Bluetooth USB dongle.
When you have established Bluetooth connection between your PC and the
LUCAS device you are able to give the LUCAS device a description (i.e. Medic 10
or ED 5). This description must be no longer than 32 characters.
The device description can also be edited within your prole in LIFENET under
”Assets / edit asset” later on.
You can nd the serial
number on the inside
of LUCAS support leg.
Back to contents

Stryker LUCAS 3 Specifications

General

Device Type	Chest Compression System
Power Source	Rechargeable Lithium-ion Battery
Compression Depth	5.3 ± 0.2 cm (2.1 ± 0.1 in)
Battery Life	45 minutes of operation
Battery Charge Time	Approximately 4 hours
Operating Modes	Pause
Patient Size	Fits most adult patients
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	–20 to +60 °C (–4 to 140 °F)
IP Rating	IP43
Compression Rate	100 compressions per minute