• Needle nose pliers
• Syn-Tech grease (3000-200-719)
PPrroocceedduurree::
1. Raise the product to the highest height position.
2. On the footboard control panel, press EEnntteerr to access the SSeettttiinnggss menu.
3. Highlight SShhuuttddoowwnn and press EEnntteerr.
4. Unplug the power cord from the wall outlet.
5. Push down on the brake pedal to apply the brake.
6. Expand all litter decks to the 48 in. position.
7. Raise the siderail to the up and locked position.
8. Using a T15 Torx driver, remove the two screws that secure the junction board assembly to the siderail carrier. Remove
the junction board assembly.
9. Unplug the two siderail cables from the junction board assembly.
10.Using a T27 Torx driver, remove the screw that secures the guide rod to the litter.
11.Push the siderail release button to lower the siderail to the lowest stowed position.
12.Using needle nose pliers, from under the litter surface, slide each glide rod out.
NNoottee -- Save the two rubber washers on each glide rod, one on both sides of the siderail carrier, to reinstall. Use Syn-
Tech grease to lube the glide rod, if required.
13.While supporting the rail with one hand, remove both glide rods and remove the siderail assembly.
14.Reverse steps to reinstall.
15.Verify proper operation of the product before you return it to service.
IIVV ppoollee aattttaacchhmmeenntt
TToooollss rreeqquuiirreedd::
• 3/8” ratchet
• 3/16” hex driver
• 1/2” socket
• 9/16” socket
PPrroocceedduurree::
1. Using a 3/16” hex driver, remove and save the power cord retainer shoulder bolt and strap on both sides of the product.
2. Using a 1/2” socket, secure the bracket with the IV pole assembly to the left side of the product with the two supplied
bolts and washers.
3. Using a 1/2” socket, secure the bracket with the rest block to the right side of the product with the two supplied bolts and
washers.
4. Using a 3/16” hex driver, secure the power cord retainer shoulder bolt and strap on both sides of the product through
both brackets.
5. Verify proper operation of the product before you return it to service.
PPaattiieenntt hheellppeerr aattttaacchhmmeenntt
TToooollss rreeqquuiirreedd::
• 3/8” ratchet
EN 34 5900-009-002 Rev A.0
To Next Page
Loading...
Need help?
General
