11
SN 94770 - ...
1
2 3
4
5
Stûv 30-compact - installation [en] - 01/13
Unpacking
> Remove the wooden structure using
a claw hammer [photo 1].
> Remove the plastic packaging
[photo 2] and the plastic films at the
top and bottom of the stove which
hold the mobile parts in place during
transport [photo 3].
Note ! The hand-lift truck protection
[photo 4] supports the stove during
handling to avoid putting pressure
on the doors or the drum. It is later
removed when the stove is moved
into its final position.
Please note ! Never undo the two
screws holding the support panel in
place : it is factory adjusted and fixed
[photo 5].
To Next Page
