2222
INSTALLING REMOTE RECEIVER MODELS SSD24TR AND SSD30TR
The remote receiver operates on four 1.5V AA-size batteries. Use ALKALINE batteries
for longer battery life and maximum microprocessor performance.
IMPORTANT: New or fully charged batteries are essential for proper operation of the
remote receiver as the solenoid power consumption is higher than standard remote control
systems.
1
. Remove battery cover along the direction shown on the battery box, and install four
1.5V AA-size batteries into the box. (See Figure 36)
2. Rotate the log set and connect two wires (black and red) with two wires from AF-1100
valve. (See Figure 37)
3. With receiver wired to the valve, place receiver to the side of the log set. (See Figure 38)
Figure 36
Figure 37
Figure 38
Red wire
Black wire
To Next Page
Loading...
