Style selections SSD24TR - Lighting Instructions; Vent-Free Gas Logs & 24 In. Vent-Free Gas Logs; To Turn off Gas to Appliance; Match Lighting Instructions

24
CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.
1. Unscrew ignitor cap and install a AAA type battery with the anode (+) pointing out.
Replace cap.
2. STOP! Read the safety information on front and back of the warning plate.
3. Make sure manual shutoff valve is fully, open.
4. Push in gas control knob slightly and turn clockwise to the OFF position.
5. Wait ve (5) minutes to clear out out any gas. Then smell for gas, including near the
oor. If you smell gas, STOP! Follow "B" in the safety information label. If you do not
smell gas, go to the next step.
6. Push in gas control knob slightly and turn counterclockwise to “PILOT” and
depress for ve (5) seconds. NOTE: The rst time the heater is operated after
connecting the gas supply, the control knob should be depressed for about thirty(30)
seconds. This will allow air to bleed from the gas system.
7. With control knob pushed in, press and hold ignitor button, located on the other side
of front panel. This will light the pilot. If needed, keep ignitor button pressed until pilot
lights.
8. Continue pushing the control knob in for a further 60 seconds to allow themocouple to
warm up. Release the control knob.
Note: If pilot goes out, repeat steps 3 through 7. This heater has a safety interlock
system. W
ait one (1) minute before lighting pilot again.
9. Turn control knob counterclockwise to desired heating level. The main burner should
light. Set control knob to any heat level between 1 and 5.
TO TURN OFF GAS TO APPLIANCE
Shutting Off Heater
Turn control knob clockwise to the OFF position.
Shutting Off Burner Only (pilot stays lit )
Turn control knob clockwise to the PILOT position.
LIGHTING INSTRUCTIONS
MATCH LIGHTING INSTRUCTIONS
1. Remove any items necessary for easy access to the pilot (for example: logs,
screens, etc.).
2
. Follow appropriate lighting instructions found above. Instead of pushing the piezo
button, light a match and hold the ame to the end of the pilot and ignite the pilot.
3.
After control knob has been released and pilot stays lit, reinstall any items that
were removed for pilot access.
4.
Call a qualied service technician for repair or replacement of the piezo ignitor.
18 IN. VENT-FREE GAS LOGS & 24 IN. VENT-FREE GAS LOGS