Style selections SSD24TR - TROUBLESHOOTING AND PARTS; Troubleshooting Guide

3131
LOGS
If you remove logs for cleaning, refer to "Installing Logs" to properly replace logs.
Replace log(s) if broken or chipped (dime-size or larger).
MAIN BURNER
Periodically inspect all burner ame holes with the heater running. All slot burner ame
holes should be open with yellow ame present.
All round burner flame holes should be open with a small blue flame present. Some
burner ame holes may become blocked by debris or rust, with no ame present. If so,
turn off heater and let cool. Either remove the blockage or replace the burner. Blocked
burner ame holes will create soot.
•
•
WARNING: If you smell gas
Shut off gas supply.
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in your building.
Immediately call your gas supplier from a neighbor’s phone. Follow the gas
supplier’s instructions.
If you cannot reach your gas supplier, call the re department.
IMPORTANT: Operating heater where impurities in air exist may create odors.
Cleaning supplies, paint, paint remover, cigarette smoke, cements and glues, new
carpet or textiles, etc., create fumes. These fumes may mix with combustion air and
create odors.
WARNING: Only a qualied service technician should service and repair heater.
CAUTION: Never use a wire, needle, or similar object to clean ODS/pilot. This can
damage ODS/ pilot unit.
N
OTE: All troubleshooting items are listed in order of operation.
•
•
•
•
•
•
TROUBLESHOOTING