Style selections SSD24TR - INSTALLATION AND GAS CONNECTION; Local Codes and Preparation

6
LOCAL CODES
lnstall and use heater with care. Follow all local codes. In the absence of local codes, use
the latest edition of The National Fuel Gas Code, ANSI Z223.1/NFPA 54.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, lnc.
1 Batterymarch Park
Quincy, MA 02269-9101
State of Massachusetts: The installation must be made by a licensed plumber or gas
tter in the Commonwealth of Massachusetts.
Sellers of unvented propane or natural gas-fired supplemental room heaters shall
provide to each purchaser a copy of 5
27 CMR 30 upon sale of the unit.
In the state of Massachusetts, unvented propane or natural gas-fired space heaters
shall be prohibited in bedrooms and bathrooms.
In the State of Massachusetts the gas cock must be a “T” handle type. The State
of Massachusetts requires that a exible appliance connector cannot exceed
three feet in length.
PREPARING FOR INSTALLATION
Before beginning assembly or operation of the product, make sure all parts are present.
Compare parts with package contents list and diagram above. If any part is missing or
damaged, do not attempt to assemble, install or operate the product. Contact customer
service for replacement parts.
Estimated Assembly Time: 1 to 2 hours
Tools Required for Assembly:
Before installing heater, make sure you have the the following:
Hardware package (provided with heater)
Approved exible gas hose (not provided) if allowed by local codes
Sealant (resistant to natural or propane/LP gas, not provided)
Electric drill with 3/16- in. drill bit
Phillips screwdriver
External regulator (supplied by installer)
Piping (check local codes)
Equipment shutoff valve
Test gauge connection
Sediment trap
Tee joint
Pipe wrench
UNPACKING
1. Remove logs and burner base assembly from carton. NOTE: Do not pick up burner
base assembly by burners as this could damage heater. Always handle base
assembly by grate.
2. Remove all protective packaging applied to logs and heater for shipment.
3. Check all items for any shipping damage. If damaged, promptly inform dealer where
you purchased the heater.
•
•
•
•
•
•
•
•
•
•
•
•