If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Keyless access setting (models
with “keyless access with push-
button start system”)
! Preparation for keyless access
settings
1. Perform the preparation steps accord-
ing to “Preparation for car settings” F3-85.
2. Operate the “ ” or “ ” switch to
select the “Keyless Access Setting” item.
Then push the
button.
! Driver’s door unlock setting
1. Perform the preparation steps accord-
ing to “Preparation for keyless access
settings” F3-91.
2. Operate the “ ” or “ ” switch to
select the “Driver’s Door Unlock” item.
Then push the
button.
3. The current setting will be displayed.
Push the
button to enter the selection
mode.
Instruments and controls/Multi function display
– CONTINUED –
3-91
To Next Page
Loading...
