34
Settings
2 Menu "set 2"
With menu "set 2" or Dive.Log you can configure the following items:
Setting Range Default Page
• Alarm clock
• UTC zone
• Time of day
• 24 or AM/PM setting
• Date
• Display contrast
• IrDA speed (set 2 only)
• Sound
• Show XP10 electronic ID
0 - 23h 59min, on/off
±13hrs, increments: 15min
hours:minutes
24 (off) / AM/PM (on)
1 (low) -12 (high)
low / high
on / off
12:00, off
4
low
on
34
34
34
35
35
35
35
35
36
Starting from the time of day display push
or until "set 2"
appears.
Confirm that you wish to enter into the menu of "set 2" by pushing
.
Once entered into the menu you can scroll with and through
the menu.
Setting the alarm clock time
The alarm clock goes off only at the surface. "Sound" must be turned "on"
in "set 2".
1. Confirm that you wish to set the alarm time by pushing
.
The hours start to flash.
2. Set the hours by pushing
or .
3. Confirm the setting with . The minutes start to flash.
4. Set the minutes by pushing or .
5. Confirm the setting with
. "On" or "off" starts to flash.
6. "On" indicates "activated" (time of day display shows ), "off" indicates
"deactivated". Switch between "on" or "off" by pressing .
7. Confirm the selected status with .
Setting the UTC offset (coordinated universal time)
This setting allows you to quickly set the watch to a new time zone without
affecting the actual time setting.
1. Confirm that you wish to set the UTC offset by pushing
.
The hours start to flash.
2. Set the hours by pushing or (±13hrs).
3. Confirm the setting with . The minutes start to flash.
4. Set the minutes in increments of 15 minutes by pushing
or .
6. Confirm the selected status with .
Adjusting the time of day
You can adjust it to your time zone either in this menu or using the UTC
offset (see above).
1. Confirm that you wish to adjust the time of day by pushing
.
The hours start to flash.
2. Set the hours by pushing
or .
3. Confirm the setting with . The minutes start to flash.
4. Set the minutes by pushing or .
5. Confirm the setting with .
To Next Page
Loading...
