TABLE OF CONTENTS
SECTION 4—INSTALLATION
101 4.1 COMPRESSOR MOUNTING— SUPPORT AND LOCATION
101 4.2 VENTILATION AND COOLING
105 4.3 SERVICE AIR PIPING
105 4.4 COUPLING ALIGNMENT CHECK
105 4.5 FLUID LEVEL CHECK
106 4.6 ELECTRICAL PREPARATION
106 4.7 MOTOR ROTATION DIRECTION CHECK
SECTION 5—SUPERVISOR CONTROLLER
SECTION 6—MAINTENANCE
111 6.1 GENERAL
111 6.2 DAILY OPERATION
111 6.3 MAINTENANCE AFTER INITIAL 50 HOURS OF OPERATION
111 6.4 MAINTENANCE EVERY 2000 HOURS
111 6.5 FLUID MAINTENANCE
112 6.6 FLUID FILTER MAINTENANCE
113 6.7 AIR FILTER MAINTENANCE
114 6.8 SEPARATOR MAINTENANCE
116 6.9 FLUID RETURN/SIGHT GLASS MAINTENANCE
117 6.10 PRESSURE REGULATOR ADJUSTMENT
118 6.11 WATER CONDENSATE DRAIN MAINTENANCE
118 6.12 CONTROL LINE FILTER
118 6.13 SHAFT COUPLING MAINTENANCE
SECTION 7—TROUBLESHOOTING
119 7.1 TROUBLESHOOTING— INTRODUCTION
To Next Page
Loading...
Need help?
General
