SECTION 3 TS20C USER MANUAL
77
Identification—TS20C (Typical)
NOTES
1. ALLOW 4' MINIMUM CLEARANCE AROUND MACHINE FOR
ACCESS AND FREE CIRCULATION OF AIR.
2. A FOUNDATION OR MOUNTING CAPABLE OF SUPPORTING THE
WEIGHT OF THE MACHINE AND RIGID ENOUGH TO MAINTAIN
THE COMPRESSOR FRAME LEVEL AND THE COMPRESSOR IN
ALIGNMENT IS REQUIRED. THE COMPRESSOR FRAME MUST
BE LEVELED AND SECURED WITH FOUNDATION BOLTS, AND
FULL UNIFORM CONTACT MUST BE MAINTAINED BETWEEN THE
FRAME AND FOUNDATION. IT IS RECOMMENDED THAT THE
FRAME BE GROUTED TO THE FOUNDATION. THE COMPRES-
SOR UNIT AND DRIVER MUST BE ALIGNED (IF APPLICABLE)
AFTER THE FRAME INSTALLATION IS COMPLETED AS SPECI-
FIED IN THE OPERATORS MANUAL. NO PIPING LOADS SHALL
BE TRANSMITTED TO THE MACHINE BY EXTERNAL CONNEC-
TIONS.
3. ALL DIMENSIONS ARE +/- 1/2".
4. APPROX. PACKAGE WEIGHT: SEE TABULATION
5. RECOMMENDED INCOMING CUSTOMER POWER SUPPLY TO BE
ON UPPER LEFT SIDE OF ELECTRICAL ENCLOSURE.
AIR OUTLET SIZE
PACKAGE
HORSEPOWER
AIR OUTLET
PORT SIZE
100HP 2” NPT
125HP 2” NPT
150HP 2-1/2” NPT
PACKAGE WEIGHTS
PACKAGE
HORSEPOWER
WEIGHT W/O
ENCLOSURE
WEIGHT
W/
ENCLOSURE
WEIGHT
W/BUSTLED
ENCLOSURE
100HP 6,400# 7,350# 7,400#
125HP 6,650# 7,600# 7,650#
150HP 6,950# 7,900# 7,950#
To Next Page
Loading...
