Summa F1612 - Calibration and Automatic Depth Control

Table of Contents II
2 Setting up modules / tools ...................................................... 14
2.1 Introduction ................................................................................................. 14
2.1.1 General remarks on the calibration of the tools ................................................. 14
2.1.2 Automatic Depth Control ..................................................................................... 14
2.1.3 Installing / Removing a module .......................................................................... 15
2.1.3.1 Installing a module ...................................................................................... 15
2.1.3.2 Removing a module ...................................................................................... 15
2.2 Tool/knife calibration with ADC................................................................... 16
2.2.1 General calibrations with the ADC ....................................................................... 16
2.3 Calibration of the drag module .................................................................... 17
3 Axis Control, remote & Plug-in ................................................ 18
3.1 Axis Control ................................................................................................. 18
3.1.1 Main Window ........................................................................................................ 18
3.1.2 Media menu .......................................................................................................... 20
3.1.3 Change Tool ......................................................................................................... 20
3.1.4 Reset .................................................................................................................... 21
3.1.5 Modules ................................................................................................................ 21
3.1.6 Load...................................................................................................................... 22
3.1.7 Menu ..................................................................................................................... 22
3.1.8 Events ................................................................................................................... 22
3.1.9 Reboot .................................................................................................................. 23
3.1.10 Color Axis Control icon ........................................................................................ 23
3.1.11 Axis Control options when table is busy cutting jobs from Summa GoProduce 23