1
1 MACHINE COMPONENTS
1.1 Safety and Ideal Operating Environment
1.1.1 Safety
1.1.1.1 General
The purpose of the user’s manual is not only to explain the operating procedures in order to
operate this machine. It also provides the owner, users and operators with precautionary
procedures for safe and proper machine operation for its intended purpose.
All information in this manual must be read and understood before any attempt is made to
operate the machine.
The manufacturer has no direct control over the machine operation and application. Proper
safety practice is the sole responsibility of the owner, user and operator.
All instructions and safety warnings in this manual are based upon the use of this machine
under proper operating conditions without alterations from the original design.
The proper use and the limits of the application of the cutting table depend on the module and
tool, used in combination with the material.
Any use of the flatbed that is beyond the capabilities of the combination tool/material is
considered as improper use and may result in injury and/or serious damage to the machine
and will lead to loss of warranty.
The installation of the machine, accessories and spare parts must not be done by untrained or
unauthorized persons. Also, the described maintenance procedures need to be followed and
performed by trained personnel.
1.1.1.2 Symbols used in this manual
Warning with dark (red) symbol: Refers to immediate threat that can
cause serious injuries and effects on health and safety.
Warning with light (yellow) symbol: Refers to a dangerous situation
that can cause injuries and serious damage to the machine.
Attention with dark (red) symbol: Refers to useful information to
prevent damage to the equipment and prolong the service life of the
Attention with light (yellow) symbol: Refers to useful tips to enhance
user-friendliness and make the work significantly easier.
Note: Can be considered as a general tip, something that is useful
to know.
To Next Page
Loading...
