setcod(8)
158 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
If you run the setcod command without specifying any options, the command
prompts you for COD information.
You are asked to specify the amount of COD headroom to be used, and the number
of COD RTU licenses to be reserved for your domains. When you are prompted for
COD information, the maximum values allowed are displayed within parentheses
() and default values are displayed within brackets [].
setcod enables COD headroom (processors to be used on demand). Use the -d
domain_id to specify the number of domain COD RTU licenses to be reserved.
EXAMPLES
EXAMPLE 1 Setting COD CPU Headroom Quantity and Reserve Domain COD RTU Li-
censes
headroom Amount of headroom (processors) to be enabled. Maximum
value is 4.
proc-rtus The number of Right To Use (RTUs) licenses reserved for a
domain. One RTU license is required for each CPU.
XSCF> setcod
PROC RTUs installed: 0
PROC Headroom Quantity (0 to disable, 4 MAX) [0]: 1
WARNING:Using headroom requires you to install license key(s) within 30
days. Do you agree? [y|n]: y
PROC RTUs reserved for domain 0 (1 MAX) [0]:
PROC RTUs reserved for domain 1 (0 MAX) [0]:
PROC RTUs reserved for domain 2 (0 MAX) [0]:
PROC RTUs reserved for domain 3 (0 MAX) [0]:
PROC RTUs reserved for domain 4 (0 MAX) [0]:
PROC RTUs reserved for domain 5 (0 MAX) [0]:
PROC RTUs reserved for domain 6 (0 MAX) [0]:
PROC RTUs reserved for domain 7 (0 MAX) [0]:
PROC RTUs reserved for domain 8 (0 MAX) [0]:
PROC RTUs reserved for domain 9 (0 MAX) [0]:
PROC RTUs reserved for domain 10 (0 MAX) [0]:
PROC RTUs reserved for domain 11 (0 MAX) [0]:
PROC RTUs reserved for domain 12 (0 MAX) [0]:
To Next Page
Loading...
Need help?
General
