showfru(8)
System Administration 357
NAME showfru - display the hardware settings of specified device
SYNOPSIS showfru device location
showfru -a device
showfru -h
DESCRIPTION The showfru(8) command displays the hardware settings of specified device by the
setupfru(8) command.
The command can display the settings of the specified device or of all devices. Only
the physical system board (PSB) can be specified as a device.
The following settings are displayed:
Privileges You must have platadm or fieldeng privileges to run this command.
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported.
Device Specified device name. Only sb is displayed.
Location Device location. If the device is "sb", the indicated location is an
integer ranging from 00 to 15.
XSB Mode XSB mode set for the PSB. One of the following values is
displayed:
Uni Uni-XSB
Quad Quad-XSB
Memory Mirror
Mode
Memory mirror mode set for the PSB. One of the following
values is displayed:
yes Memory mirror mode
no Memory no-mirror mode
-a Displays the settings of all devices.
-h Displays usage statement. When used with other options or
operands, an error occurs.
To Next Page
Loading...
Need help?
General
