showroute(8)
System Administration 425
NAME showroute - display routing information for an XSCF network interface
SYNOPSIS showroute [-M][-n]{-a | interface}
showroute -h
DESCRIPTION showroute(8) command displays the current routing information for an XSCF
network interface.
Routing information for the specified network interface or all the network interfaces
can be displayed. The following information is displayed:
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
Destination Destination IP address
Gateway Gateway address
Netmask Netmask address
Flags Flag which indicates the status of specified routing
U route is up
H target is host
G use gateway
R reinstate route for dynamic routing
C cache entry
! reject route
Interface XSCF network interface name
-a Displays routing information that is set for all XSCF network
interfaces.
To Next Page
Loading...
Need help?
General
