showroute(8)
426 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
The setroute(8) command sets routing information for the XSCF network.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-M Displays text by page. This option provides a function that is the
same as that of the more command.
-n Displays IP address without the name resolution of host name.
interface Specifies the network interface whose information is to be
displayed. One of the following values can be specified,
depending on the system configuration. If this operand is
specified with the -a option, the operand is ignored.
â– In the M3000/M4000/M5000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For abbreviation:
lan#0 XSCF-LAN#0
lan#1 XSCF-LAN#1
â– In the M8000/M9000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For XSCF unit 1 :
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
To Next Page
Loading...
Need help?
General
