showntp(8)
System Administration 415
NAME showntp - display the NTP information which currently set for XSCF
SYNOPSIS showntp {-l | -a | address | -s | -m}
showntp -h
DESCRIPTION The showntp(8) command displays the NTP information currently set for XSCF.
The showntp(8) command can display the following information:
â– NTP servers which have been registered to the XSCF network
â– Status of synchronization with the NTP servers
â– Stratum value which has been set to XSCF
â– Designation of preferred server
Privileges You must have one of the following privileges to run this command:
useradm, platadm, platop, auditadm, auditop, domainadm, domainmgr,
domainop, fieldeng
Refer to setprivileges(8) for more information.
OPTIONS The following options are supported:
-a Displays all the NTP servers currently set for the XSCF network.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-l Displays whether synchronization with an NTP server is being
maintained.
-m Displays whether a preferred server designated. Either of the
following is displayed:
on Preferred server has been designated.
off Preferred server not designated.
-s Displays the stratum value which has been set to XSCF.
To Next Page
Loading...
Need help?
General
