setdcl(8)
System Administration 169
OPERANDS The following operands are supported:
EXTENDED
DESCRIPTION
â– If the XSB associated with the specified LSB has been configured in the domain
configuration, the information that is set for the LSB cannot be changed. Before
making such a change, unassign the XSB from the domain configuration by
executing the deleteboard(8) command, or re-configure it in another domain
configuration by executing the moveboard(8) command.
â– If the specified domain is running, the value of policy cannot be changed. To
change the value, first turn off power to the domain.
â– The currently set DCL information can be checked by using the showdcl(8)
command.
EXAMPLES
EXAMPLE 1 Sets XSB#00-0 for LSB#00 and XSB#00-1 for LSB#01 of domain ID 0.
EXAMPLE 2 Sets no-mem=true for LSB#00 and #01 of domain ID 0.
If no-io is specified for option, either of the following can be
specified for value:
true Omits the use of I/O devices on a domain.
false Does not omit the use of I/O devices on a
domain (default).
If float is specified for option, either of the following can be
specified for value:
true Gives a higher priority regarding floating
boards.
false Does not give a higher priority regarding
floating boards (default).
lsb Specifies the number of the LSB whose information is to be set.
Specify by using an integer ranging from 0 to 15. Multiple lsbs
can be specified by delimiting with spaces. Specifies unique lsb
within the domain. If the same lsb number is specified, an error
occurs. On the M3000 server, you cannot specify this option.
XSCF> setdcl -d 0 -a 00=00-0 01=00-1
XSCF> setdcl -d 0 -s no-mem=true 00 01
To Next Page
Loading...
Need help?
General
