setroute(8)
238 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised April 2009
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
■ If the specified address is the same as the DSCP address, an error occurs.
■ For XSCF-LAN#0 and XSCF-LAN#1, do not set the routing to the same network
or the same host.
-n address Specifies an IP address to which routing information is
forwarded. The specified value is a set of four integer values
delimited by the "." (period). The following address form is
accepted:
xxx.xxx.xxx.xxx
xxx An integer from 0–255. Zero suppression can
be used to specify the integer.
If "0.0.0.0" is specified for address, the default routing information
can be set.
interface Specifies the network interface to be set with routing
information. One of the following values can be specified:
■ In the M3000/M4000/M5000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For abbreviation:
lan#0 XSCF-LAN#0
lan#1 XSCF-LAN#1
■ In the M8000/M9000 servers:
For XSCF unit 0:
xscf#0-lan#0 XSCF-LAN#0
xscf#0-lan#1 XSCF-LAN#1
For XSCF unit 1:
xscf#1-lan#0 XSCF-LAN#0
xscf#1-lan#1 XSCF-LAN#1
To Next Page
Loading...
