setsnmp(8)
System Administration 251
default Stops the SNMP agent and changes the SNMP configuration to
the factory default settings. After using this option, SNMP must
be configured again before the SNMP agent is restarted.
When used with default, the command also stops the SNMP
agent for Sun MC in servers running Sun MC. The Sun MC
configuration is not affected, but to enable SNMP for Sun MC
again, execute the setsunmc(8) command with its -s option –
setsunmc -s sunmc-server, where sunmc-server is the server
hostname previously set – then, execute
setsnmp enable. And
then execute
setsunmc enable. For more information, see
setsunmc(8).
disable When used alone or with the value ALL for the optional
mib_name, stops the SNMP agent.
When used with a value other than ALL for the optional
mib_name, removes support for the targeted MIB module. If
support remains for another MIB module, the SNMP agent
remains enabled. If support for both MIB modules is removed,
the SNMP agent is disabled and, therefore, stops. You can specify
only one value at a time for mib_name.
mib_name
Name of the MIB module to be disabled.
Valid MIB modules are:
SP_MIB = XSCF extension MIB
FM_MIB = Fault Management MIB
ALL = All the MIB modules in this list.
disablev1v2c Disables the SNMP agent from communicating using SNMPv1/
v2c. These versions provide insecure SNMP communication.
To Next Page
Loading...
Need help?
General
