applynetwork(8)
18 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
â– Unless all of the host name, DNS domain name, IP address, net mask, and
routing settings have been made on the target interface, it results in errors.
Please execute the sethostname(8) and setnetwork(8) command to set all
items, then reexecute the applynetwork(8) command.
â– To set to multiple interfaces, all of the host name, DNS domain name, IP address,
and net mask settings need to be set on every interface. In these interfaces, if any
of these setting items omitted, it results in errors.
â– To specify a host name, use the sethostname(8) command. To specify an IP
address and net mask, use the setnetwork(8) command.
â– When the status is down in all network interfaces, it results in errors.
â– On the M8000/M9000 servers, when you set different netmask in the following
interfaces, it results in errors.
â– xscf#0-lan#0, xscf#1-lan#0, lan#0
â– xscf#0-lan#1, xscf#1-lan#1, lan#1
â– xscf#0-if, xscf#1-if
EXAMPLES
EXAMPLE 1 Reflects the information that has been set for the XSCF network.
On the M3000/M4000/M5000 servers:
XSCF> applynetwork
The following network settings will be applied:
xscf#0 hostname :hostname-0
DNS domain name :example.com
nameserver :10.23.4.3
interface :xscf#0-lan#0
status :up
IP address :10.24.144.214
netmask :255.255.255.0
route :-n 0.0.0.0 -m 0.0.0.0 -g 10.24.144.1
interface :xscf#0-lan#1
status :down
IP address :
netmask :
To Next Page
Loading...
Need help?
General
