testsb(8)
470 SPARC Enterprise Mx000 Servers XSCF Reference Manual • Last Revised September 2008
OPTIONS The following options are supported:.
OPERANDS The following operand is supported:
EXTENDED
DESCRIPTION
â– When the command is executed, a prompt to confirm execution of the command
with the specified options is displayed. Enter "y" to execute the command or "n"
to cancel the command.
â– When the system board (XSB) belonging to the specified PSB is in any status
below, the testsb(8) command results in an error.
â– XSB is installed in the domain and this domain is in operation.
-c {all|expansion} Specifies the target PSB to be diagnosed. One of the values
shown below can be specified:
all Diagnoses all the PSB that are mounted.
If the following conditions not satisfied, it leads to an error.
â– The system has been powered off.
â– All of the target PSB are Uni-XSB.
expansion Diagnoses all the PSB that are mounted
on the expansion cabinet.
If the following conditions not satisfied, it leads to an error.
â– All of the target PSB are not operating on the domain.
â– All of the target PSB are Uni-XSB.
-h Displays usage statement. When used with other options or
operands, an error occurs.
-m diag=mode Specifies the diagnostic level of initial diagnosis. One of the
values shown below can be specified:
min Normal (default)
max Maximum
-n Automatically answers "n" (no) to all prompts.
-q Suppresses all messages to stdout, including prompts.
-v Displays a detailed message of initial diagnosis.
-y Automatically answers "y" (yes) to all prompts.
location Specifies only one PSB number. An integer from 00–15 can be
specified.
To Next Page
Loading...
Need help?
General
