Sunbeam EMM7300 - Care and Cleaning - Grinder

34
Conical Burrs are used to grind coffee beans
to a suitable size for espresso extraction.
Deposits of grinds & oils build up over time,
affecting the taste of the espresso and
operation of the integrated Grinder.
Cleaning Grinding Cradle & Grind Outlet
• Weekly
Remove any coffee grinds from the
Grinding Cradle & Grind Outlet with the
Cleaning Brush and wipe with a damp
cloth, wipe dry.
Cleaning the Bean Hopper
• 2-3 Months
If the Grinder is used frequently (everyday),
the Bean Hopper needs to be cleaned to
ensure best performance.
CAUTION: To prevent damage to the
appliance do not use alkaline cleaning
agents, abrasives or metal scourers.
WARNING: Do not immerse the machine
in water.
• Preparing to Clean Bean Hopper
- Turn off the machine, switch off & unplug
at power outlet.
- Make note of the current Grind Setting (to
use as the starting point after cleaning).
• Remove and Clean Bean Hopper
- Turn Bean Hopper fully anti-clockwise, to
close the Hopper Gates and unlock the
Bean Hopper.
Remove the Bean Hopper from the Grinder
Collar and store any remaining beans
in an airtight container to preserve their
freshness.
- Wash the Bean Hopper in warm soapy
water, then rinse & dry. Let the Bean
Hopper stand to allow thorough air drying
before replacing.
• Replace Bean Hopper
- Ensure the Grinder
Collar is clear of
coffee beans or grinds.
Note: Coffee beans and grinds caught
under the Top Burr may prevent the Top
Burr from inserting properly and the
Bean Hopper will not fit correctly. See
“Cleaning Top Burr” for instructions on
emptying the grind system.
- Ensure the Hopper Guide is aligned with
the vertical white lines on the Hopper
base.
- Align & insert the Bean Hopper into the
Grinder Collar and firmly pushing down
turn clockwise to lock into place and
open the Hopper Guide.
Care and cleaning – Grinder
IMAGE IB014
CLEAR OF
COFFEE BEANS
& GRINDS
1. TURN
2. REMOVE
AIR TIGHT
CONTAINER
1. ALIGN HOPPER GUIDE
3. TURN
2. INSERT
GRINDER
OUTLET