SunFounder 3in1 Kit
The dht11, a digital temperature and humidity sensor, is provided in this kit. It uses a capacitive humidity sensor and
thermistor to measure the surrounding air and outputs a digital signal on the data pin.
Required Components
In this project, we need the following components.
It’s definitely convenient to buy a whole kit, here’s the link:
Name ITEMS IN THIS KIT LINK
3 in 1 Starter Kit 380+
You can also buy them separately from the links below.
COMPONENT INTRODUCTION PURCHASE LINK
Arduino Uno R4 Minima -
Breadboard
Jumper Wires
DHT11 Humiture Sensor -
Schematic
176 Chapter 4. Basic Projects
To Next Page
Loading...
