SunFounder 3in1 Kit
11. Finally, click Save And Apply.
3. Run the Code
1. Open the 2.get_data_from_blynk.ino file under the path of 3in1-kit\iot_project\2.
get_data_from_blynk, or copy this code into Arduino IDE.
2. Replace the Template ID, Device Name, and Auth Token with your own. You also need to enter the ssid
and password of the WiFi you are using. For detailed tutorials, please refer to 1.4 Connecting the R4 board to
Blynk.
3. After selecting the correct board and port, click the Upoad button.
6.2. 2. Get Data from Blynk 287
To Next Page
Loading...
