Sungrow SG3.0RT - Mechanical Mounting; Safety during Mounting

18
4
Mechanical Mounting
Respect all local standards and requirements during mechanical installation.
4.1 Safety during Mounting
Make sure there is no electrical connection before installation.
Before drilling, avoid the water and electricity wiring in the wall.
Poor installation environment will affect system performance!
• Install the inverter in a well-ventilated place.
• Ensure that the heat dissipation system or vent is not blocked.
• Do not install the inverter in an environment with flammable and explosive ob-
jects or smoke.
Improper handling may cause personal injury!
• When moving the inverter, be aware of its weight and keep the balance to pre-
vent it from tilting or falling.
• Wear proper protective equipment before performing operations on the inverter.
• The bottom terminals and interfaces of the inverter cannot directly contact the
ground or other supports. The inverter cannot be directly placed on the ground.
4.2 Location Requirements
Select an optimal mounting location for safe operation, long service life and expected
performance.
• The inverter with protection rating IP65 can be installed both indoors and outdoors.
• The inverter should be installed at a height that allows easy viewing of the LED indicator
panel, as well as easy electrical connection, operation and maintenance.