SunStar KM-2522 Series - 보빈 설치; Setting the Bobbin into the Bobbin Case; 실 끼우기; Threading the Machine Head

보빈 설치 그림8. ( 10)
SETTING THE BOBBIN INTO THE BOBBIN CASE (Fig.10)
보빈을 실 끝단이 오른쪽으로 개방 되도록 잡고1)
보빈케이스에 넣어 주십시오.
실을케이스의통과홈을거쳐장력스프링을통과2)
하여 방향으로 빼냅니다C.
실을 당길 때 보빈이 화살표 방향으로 회전하는지3)
확인하십시오.
1) Hold the bobbin in a way that the thread open end
is directed to the right as observed from you, and
set the bobbin into the bobbin case.
2) Pass the thread through thread slit, and pull the
thread in direction C. By so doing, the thread will
pass under the tension spring and come out from
notch.
3) Check that the bobbin rotates in the direction of
the arrow when thread is pulled.
실끼우기 그림9. ( 11)
THREADING THE MACHINE HEAD (Fig.11)
-17-
Fig.10
A
B
C
Fig.11