12. Repair and maintenance works of electrical components shall be conducted by
qualified electric technicians or under the audit and guidance of specially skilled
personnel. Whenever your find a failure of any of electrical components,
immediately
stop the machine.
13. Periodically clean the machine throughout the period of use.
14. Grounding the machine is always necessary for the normal operation of the
machine. The machine has to be operated in an environment that is free from
strong
noise sources such as high-frequency welder.
15. An appropriate power plug has to be attached to the machine by electric
technicians, Power plug has to be connected to grounded receptacle.
16.Remodel or modify the machine in accordance with the safety rules/standards
while taking all the effective safety measures. We assumes no responsibility for
damage caused by remodeling or modification of the machine.
17. The machine is only allowed to be used for the purpose intended.
Other used are not allowed.
18. Warning hints are marked with the two shown symbols.
Danger of injury to operator or service staff
Items requiring special attention
To Next Page
Loading...
Need help?
General
