SuperMax SANDER - Troubleshooting Guide: Conveyor

T Y SB 
T G: C
PROBLEM POSSIBLE CAUSE SOLUTION
Conveyor rollers run 1. Shaft coupling loose. Align shaft  ats of gear motor
intermittently. and drive roller; tighten shaft
coupling set screws.
Conveyor belt slips 1. Improper conveyor belt Adjust belt tension (page 8).
on drive roller. tension.
2. Excessive depth of cut. Reduce depth of cut;
reduce feed rate.
Stock slips on 1. Excessive depth of cut. Reduce depth of cut.
conveyor belt.
2. Tension rollers too high. Lower tension rollers (page 9).
3. Excessive feed rate. Reduce feed rate.
4. Dirty or worn conveyor Clean or replace conveyor
belt. belt.
Conveyor belt tracks 1. Belt out of adjustment. Readjust belt; (page 8).
to one side, or oscillates
from side to side. 2. Drive or driven conveyor Readjust
belt rollers misaligned.
3. Conveyor table not  at Readjust by leveling
and square. machine
4. Conveyor belt worn. Replace conveyor belt (page 19).
5. Drive roller worn Replace drive roller.
or damaged.
6. Roller bushings elongated Replace bushings.
due to excessive wear.