Supermicro A+ Server AS -1115CS-TNR - Installing the Rails; Identifying the Rails

22
Chapter 2: Server Installation
SC 119UHTS-R...
2.4 Installing the Rails
󰀨
procedure. 
The following is a basic guideline for installing the system into a rack with the rack mounting
hardware provided. You should also refer to the installation instructions that came with the

If you are installing into a two-post "telco" rack, skip to that section later in this chapter.
Identifying the Rails
The chassis comes with two sets of rack rails, one set for the right side of the chassis and
one for the left. Each set consists of an inner rail that is pre-attached to the chassis, an outer
rail that attaches to the rack, and a middle rail that slides forward in the outer rail.
Figure 2-1. Identifying the Sections of the Rack Rails
Middle Rail (not shown)--
slides forward from the
outer rail
Inner rail--
pre-attached to
the chassis
Outer rail, front
and rear brackets