Chapter 2: Server Installation
23
Figure 2-4. Installing the Chassis into a Rack
Installing the Chassis into a Rack
Installing the Chassis into a Rack:
1. Align the chassis rails (A) with the front of the rack rails (B).
2. Slide the chassis rails into the rack rails, keeping the pressure even on both sides. You
may have to depress the locking tabs while inserting. When the server has been pushed
completely into the rack, the locking tabs should "click" into the locked position.
3. If screws are used, tighten the screws on the front and rear of the outer rails.
4. (Optional) Insert and tightening the thumbscrews that hold the front of the server to the
rack.
Note: Figures are for illustrative purposes only. Always install servers into racks in the lower
B
A
To Next Page
Loading...
