45
A+ Server AS -4124GS-TNR User's Manual
Figure 3-9. Replacing a Power Supply
Handle
Release Tab
Power Supply
The system includes four hot-plug power 2000W supply modules. They automatically sense
In the event of a power supply failure, the remaining power supply will automatically take over.
The failed power module can be replaced without powering-down the system. Replace with
the same model. Replacement modules can be ordered directly from Supermicro.
light indicates that the power supply is operating.
Replacing the Power Supply
1. Unplug the AC power cord from the failed power supply module.
2. Push and hold the release tab on the back of the power supply.
3. Grasp the handle of the power supply and pull it out of its bay.
4. Push the new power supply module into the power bay until it clicks into the locked
position.
5. Plug the AC power cord back into the power supply module.
To Next Page
Loading...
