SC815 Chassis Manual
5-16
5-17
Chapter 5: Chassis Setup and Maintenance
Depending on your chassis model the SC815 chassis has a 330, 560, 600, 650,
700, 710 or 720 Watt power supply. This power supply is auto-switching capable.
All power supplies with the exception of the 710 power supply, automatically sense
and operate at a 100V to 240V input voltage. The 710 DC power supply operates
at -36DC to -75DC. An amber light will be illuminated on the power supply when the
power is off. An illuminated green light indicates that the power supply is operating.
Power Supply Failure
If the power supply unit fails, the system will shut down the power supply unit and
you will need to replace it A power supply failure is indicated by a ashing red
(0.25Hz) LED indicator.Replacement power supply units can be ordered directly
from Supermicro (see contact information in the Preface). As there is only one power
supply unit in the SC815 Chassis, power must be completely removed from the
server before removing and replacing the power supply unit for whatever reason.
5-8 Power Supply
Replacing the Power Supply
1. Power down the server and unplug the power cord. If your chassis includes
a redundant power supply (at least two power modules), you can leave the
server running and remove only one power supply.
2. Push the release tab (on the back of the power supply) as illustrated.
3. Pull the power supply out using the handle provided.
4. Replace the failed power module with the same model.
5. Push the new power supply module into the power bay until you hear a click.
6. Reconnect the power cord, power up the system and replace the chassis
cover.
Figure 5-16. Removing the Power Supply
Release Tab
To Next Page
Loading...
