SC815 Chassis Manual
6-8
Figure 6-5. Installing into an Open Rack
Installing the Chassis into a Mid-Mount Position (Telco) Rack
1. Use the two L-shaped brackets on either side of the chassis (four total).
2. Determine how far the chassis will extend out the front of the rack. Larger
chassis should be positioned to balance the weight between front and back. If
a bezel is included on your server, remove it.
3. Attach the two front brackets to each side of the chassis, then the two rear
brackets positioned with just enough space to accommodate the width of the
telco rack.
4. Finish by sliding the chassis into the rack and tightening the brackets to the
rack.
Note: gures are for illustrative purposes only. Always install servers into racks
from the bottom up.
To Next Page
Loading...
