Supermicro SC826BE1C-R920LPB - Page 100

E-6
SC826 Chassis Manual
General Jumper Settings
Jumper Jumper Settings Note
PRI_MODE1 Pins 2-3 Factory setting do not change.
PRI_MODE2 Pins 2-3 Factory setting do not change.
SEC_MODE1 Pins 2-3 Factory setting do not change.
SEC_MODE2 Pins 2-3 Factory setting do not change.
FAN_MONITOR_DIS-
ABLE
Open: Enabled (Default)
Closed: Disabled
Enables the fan speed monitor
reporting.
FANFAIL_LED_DIS-
ABLE
Open: Enabled (Default)
Closed: Disabled
Enables the FANFAIL1 LED.
BUZZER_ENB1
Open: Disabled
Closed: Enabled
Buzzer disabled*
Buzzer enabled*
*The buzzer sound indicates that a condition requiring immediate attention has
occurred.
The buzzer alarm is triggered by one of the following conditions:
1. Hard drive failure
2. Fan failure
3. System temperature over 45º Celsius.