4-1
Chapter 4: Chassis Setup and Maintenance
Chapter 4
Chassis Setup and Maintenance
This chapter covers the steps required to install components and perform
maintenance on the chassis. The only tool required is a Phillips screwdriver.
Note and heed the warnings and precautions listed in Chapter 2: Warning
Statements for AC/DC Systems, and those listed in the setup instructions.
4-1 Removing Power from the System
Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been removed from the system.
1. Use the operating system to power down the system <or node>, following the
on-screen prompts.
2. After the system has completely shut-down, carefully grasp the head of the
power cord and gently pull it out of the back of the power supply. Remove the
cords from both power supply modules.
3. Disconnect the cord from the power strip or wall outlet.
To Next Page
Loading...
Need help?
General
