1-6
X10DRW-i/X10DRW-iT Motherboard User’s Manual
Warning!
To avoid damaging the power supply or the motherboard, please use a power supply
that contains a 24-pin and two 8-pin power connectors. Be sure to connect the power
supply to the 24-pin power connector (JPWR1), and two 8-pin power connectors
(JPWR2, JPWR3) on the motherboard. Failure in doing so may void the manufacturer
warranty on your power supply and motherboard.
SXB1B (CPU1/CPU2) PCI-E 3.0x16 + x16 add-on card slot (Left)
(Note 2 below.)
SXB1C SMC-proprietary SPEC slot (Left) (See Note 2 below.)
SXB2 SMC-proprietary PCI-E 3.0x16 add-on card slot (Right)
(See Note 3 below.)
UID-SW UID Switch
(BP) USB 0/1 (3.0) Backpanel USB 3.0 Port 0/ Port 1
(BP) USB 2/3 (3.0) Backpanel USB 3.0 connections 2/3
(FP) USB 4/5 (3.0) Front Accessible USB 3.0 connections header 4/5
VGA Backpanel VGA port
X10DRW-i(T) LED Indicators
LED Description State Status
LED1 Rear UID LED Blue: On Unit Identied
LED2 Onboard PWR LED On System Power On
LEDM1 BMC Heartbeat LED Green: Blinking BMC Normal
Note 1: For SAS support, be sure to use an SMC-proprietary mezzanine
card. Install the mezzanine card on the AOM PCIE 3.0 x16 slot (J35) for
SAS 3.0 support. Refer to Section 1-8 and Section 2-6 for more information.
Note 2: For SXB1A/SXB1B/SXB1C PCI-E slot to work properly, please use
an SMC-proprietary riser card (eg. RSC-R1UW-2E16) in the slot
Note 3: For SXB2 (CPU2 PCI-E 3.0X16) slot to work properly, please use
the SMC-proprietary riser card (PN: RSC-R2UW-2E8R).
Note 4: For the latest CPU/memory updates, please refer to our website
at http://www.supermicro.com/products/motherboard.
To Next Page
Loading...
