Supermicro SUPERO X10DRW-i - Motherboard Features

Chapter 1: Overview
1-7
Motherboard Features
CPU
• Dual Intel
®
E5-2600V3 Series Processors (Socket
R3-LGA 2011); each processor supports dual full-
width Intel QuickPath Interconnect (QPI) links (of up
to 9.6 GT/s one direction per QPI)
Memory
• Integrated memory controller supports:
Up to 1024 GB of 288-pin Registered (RDIMM)/Load
Reduced (LRDIMM) DDR4 ECC 2133/1866/1600 MHz
in 16 slots (2 DIMMs per channel).
Note 1: Memory speed support is dependent
upon the CPUs installed in the motherboard.
Note 2: For the latest CPU/memory updates,
please refer to our website at http://www.super-
micro.com/products/motherboard.
DIMM sizes
• DIMM Up to 64GB @ 1.2V
Chipset
• Intel® PCH C612
Expansion
• One (1) SMC-proprietary PCI-E 3.0 x16 slot (Right)
(SXB2) (See Note 3 on Page 1-6.)
• One (1) (CPU1+CPU2) SMC-proprietary PCI-E 3.0
x16 + x16 slot (Left) (SXB1B) (Note 2 on Page 1-6),
• One (1) PCI-E 3.0 x16 Add-On-Module (AOM) slot
for the mezzanine HBA card (J35) (See Note 1 on
Page 1-6.)
Slots
Graphics
• Graphics controller via the Aspeed AST2400 BMC
Network
• Intel i350 Gigabit (10/100/1000 Mb/s) Ethernet con-
troller for LAN 1/LAN 2 ports (X10DRW-i only),
• Intel X540 10_Gigabit Ethernet controller for LAN 1/
LAN 2 ports (X10DRW-iT only)
• Aspeed 2400 Base-board Controller (BMC) supports
IPMI_LAN 2.0
I/O Devices
SATA Connections
• SATA Ports Ten (10) SATA 3.0 ports (I-SATA
0-5, S-SATA0-3)
• RAID RAID 0, 1, 5, 10
IPMI 2.0
• IPMI 2.0 supported by Aspeed AST 2400