Supermicro SuperServer 1029GQ-TRT - Page 84

SuperServer 1029GQ-T(N/X/V)RT User's Manual
84
SATA Controller
This item enables or disables the onboard SATA controller supported by the Intel PCH
chip. The options are Disable and Enable.
CongureSATAas


AHCI, and RAID.
SATA HDD Unlock
Select Enable to unlock SATA HDD password in the OS. The options are Enable and
Disable.
Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power usage of
the SATA link. The controller will put the link in a low power mode during extended periods
of I/O inactivity, and will return the link to an active state when I/O activity resumes. The
options are Disabled and Enabled.
*If the item above "Congure SATA as" is set to RAID, the following items will
display:
SATA Port 0 ~ Port 3
This item displays the information detected on the installed SATA drive on the particular
SATA port.
• Model number of drive and capacity
• Software Preserve Support
Port 0 ~ Port 3 Hot Plug
Set this item to Enabled for hot-plugging support, which will allow the user to replace a
SATA drive without shutting down the system. The options are Disabled and Enabled.
Port 0 ~ Port 3 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disabled and Enabled.
Port 0 ~ Port 3 SATA Device Type

a Solid State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid
State Drive.