C-2
SUPERSERVER 5018D-MHR7N4P User's Manual
Note: At this point, you may decide if you want to start with BIOS Recovery. If you
decide to proceed with BIOS Recovery, follow the procedures below.
5. When the screen shown above displays, use the arrow keys to select the item
recovery progress as shown in the screen below.
Note: Do not interrupt
Note:
rename it "Super ROM".
2. Insert the USB device that contains the new BIOS image ("Super.ROM") into
your USB drive and power on the system
3. While powering on the system, keep pressing <Ctrl> and <Home> simultane-
ously on your keyboard until your hear two short beeps. This may take from a
few seconds to one minute.
4. After locating the new BIOS binary image, the system will enter the BIOS
recovery menu as shown below.
To Next Page
Loading...
Need help?
General
