17
Chapter 1: Introduction
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JRU1 Front Control Board (JFP1) Signal Reset
Pins 1-2 UID (Default)
Pins 2-3 Reset
LED Description Status
LE1 Power LED LED On: Onboard Power On
LED1 BMC Heartbeat LED Blinking Green: BMC Normal
LED2 UID LED
Connector Description
AIOM1 PCIe 5.0 (default x8) AIOM (Advanced I/O Module)
AIOM2 PCIe 5.0 (default x0) AIOM (Advanced I/O Module)
BT1 Onboard Battery
COM1 COM Port
FAN1 – FAN6 CPU/System Fan Headers (FAN1: CPU Fan)
JAIOM1_1 PCIe 5.0 x8 Input Connector for Upgrading AIOM1 to PCIe 5.0 x16
JAIOM2_1 Right-Angle PCIe 5.0 x8 Input Connector for Upgrading AIOM2 to PCIe 5.0 x8
JAIOM2_2 PCIe 5.0 x8 Input Connector for Upgrading AIOM2 to PCIe 5.0 x16 (with JAIOM2_1 in use)
JF1 Front Control Panel Header
JFP1 Front Control Board Header for Signals (can be used independently)
JFP2
JIPMB1 4-Pin BMC External I²C Header
JL1 Chassis Intrusion Header
JM2_1 – JM2_2 PCIe 3.0 x2 M.2 Slots from PCH (Support M-Key 2280 and 22110)
JOH1 Overheat/Fan Fail LED Header
JNCSI1 NC-SI Header for IPMI Support
JNVME1 – JNVME8
PCIe 5.0 x4 MCIO Ports with Support of NVMe Connections (0/1/2/3/4/5/6/7) or Upgrading
for Riser and AIOM
JPCIE1 PCIe 5.0 x8 Upgrading Connector for AIOM, NVMe, or Riser
JPI
2
C1 Power I
2
C System Management Bus (Power SMB) Header
JPWR1 24-pin ATX Power Connector (Required)
JPWR2 – JPWR3
12V 8-pin CPU Power Connector (To provide alternative power for special enclosure when
the 24-pin ATX power is not in use.)
JS1 SATA 0-7 Intel PCH SATA 3.0 Ports
JS2 SATA 8-11 Intel PCH SATA 3.0 Ports
JSTBY1 Standby Power Header
To Next Page
Loading...
