50
Chapter 3: Maintenance and Component Installation
Figure 3-13. Installing the Expansion Card
Installing Expansion Cards
(Figure on next page)
1. Use the control panel to power down the computing node, and pull the node drawer out
of the chassis.
2. Open the PCI slot clip in the rear of the node drawer and remove the PCI slot shield.
3. If the riser card is not already installed, push it into the motherboard slot.
4.
into the opening in the rear of the node drawer.
5. Close the PCI slot clip to secure the expansion card shield.
6. Secure the riser card screw.
7. Return the node drawer and power-up.
To Next Page
Loading...
