Supermicro SuperServer SYS-111C-NR - Page 61

61
Chapter 4: Motherboard Connections
ME Manufacturing Mode

        

Manufacturing Mode
Jumper Settings
Jumper Setting Denition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
NCSI Port Selection
Jumper Settings
Jumper Setting Denition
Short (ON) IPMI Access on LAN1
Open (OFF) IPMI Access on LAN2
IPMI Shared LAN Port Selection
JNCSI1 is used to set access to a LAN port for shared IPMI. Only a single port can be used

                
access port and 10GbE Ethernet port. Ethernet functionality remains enabled on both LAN1
and LAN2 regardless of which setting is used.
VGA Enable/Disable
JPG1 allows you to enable or disable the VGA port using the onboard graphics controller.
VGA Enable/Disable
Jumper Settings
Jumper Setting Denition
Pins 1-2 Enabled
Pins 2-3 Disabled