109
Chapter 7: Troubleshooting and Support
Note: Do not interrupt this process until the BIOS ashing is complete.
9. The screen above indicates that the BIOS update process is complete. When you see the
screen above, unplug the AC power cable from the power supply, clear CMOS, and plug
the AC power cable in the power supply again to power on the system.
10. Press <Del> continuously to enter the BIOS Setup utility.
11. Press <F3> to load the default settings.
12. After loading the default settings, press <F4> to save the settings and exit the BIOS Setup
utility.
To Next Page
Loading...
